Kit includes: ¥ Diaphragm ¥ Needle & seat ¥ Flange/mounting gasket (2) ¥ Air filter gasket ¥ Float bowl chamber gasket ¥ Damper assembly gasket ¥ Bypass housing gasket ¥ Bypass valve diaphragm gaskets (3) Note: Bypass diaphragm is not included in the kit. ¥ Choke gasket ¥ 8mm shaft seals (rubber, two per kit) ¥ 8mm shaft cup (brass, two per kit) ¥ Mixture adjusting screw O-ring ¥ Small washer, bypass diaphragm ¥ Temperature compensator seal, inner ¥ Temperature compensator seal, outer ¥ Bowl plug O-ring ¥ Silicone grease to lubricate shaft seals and O-rings (not shown in photo) ¥ Kits are made in the USA. During a rebuild, we also suggest you replace the following: ¥ Bypass Diaphragm (part number 03-64-014A) ¥ Carburetor insulation block (part number CO-33060) ¥ Temperature compensator plastic cover (part number 03-B17933P) ¥ Float (part number 03-6175 is our upgraded Nitrophyl float that will not crack or absorb fuel) ¥ You might also pick up a bottle of the proper damper oil, part number 03-BDR125. ¥ Finally, the top-cover screws are often damaged. A four-piece set that also includes washers is part number 03-019654P.